Oops - make that MS54-9J. Fat finger got me - Jim. KL7CC
Jim Wiley wrote: > Pete - > > > What you are looking for is a pair of "flush cutting" wire cutters. > These are offered by several manufacturers. Cooper tools (Xcelite), > and Klein tools come to mind. Available at most competent hardware > stores, and from practically any telecommunications supplier (like > Graybar). I have these in two or three different sizes. The Xcelite > MS5-9J is almost ideal for Elecraft kit work. They have several > similar models. The ones with the "J" in the model number are > flush-cut types > > - Jim, KL7CC > > > > > Pete Smith wrote: > >> This is only tangential to Elecraft (via kit assembly) but I am looking >> for a good pair of small side cutter pliers (I think that's the right >> nomenclature) to use in PC board assembly. The problem with most I have >> seen is that they have a small angled area before the cutting edge on >> the non-recessed side, which prevents my cutting wire leads as close to >> the top of the solder bulge on the bottom of the PC board as I would >> like. If you know of a good specific model number or maker, I'd >> appreciate a direct e-mail. I'll summarize for the group if there is >> interest. >> >> >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
