Bugs item #2005148, was opened at 2008-06-28 15:12 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=2005148&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: GUI - AXIS Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Stuart W Stevenson (swstevenson) Assigned to: Chris Radek (cradek) Summary: restarting in the middle of the program - set next line Initial Comment: VERSION PRE-2.3 CVS HEAD When starting in the middle of the program we should be able to pick any line to start from ie. t02m06 or n205 or g43h06 or any motion line if the control will read the program to the selected line and set all the parameters to the same states as the control would have if the program had been run to the line from the beginning of the program. I can't seem to start the program on any line except a motion line that will highlight a displayed motion line. I would like to be able to start at the m06 line using the 'execute next line' command and not have any motion happen until after the tool change has been completed. Even better would be the ability to start at any arbitrary line. ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=2005148&group_id=6744 ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
