On 05/23/2014 08:06 PM, Gene Heskett wrote: ... snip > Having G76 do a pipe thread like taper would be nice, but it already has > too many arguments. :) > > Cheers, Gene Heskett >
There was one parameter left -- D. I just need to figure out what it will be -- delta X, slope, or angle. I looked at the Fanuc commands. One uses two blocks and they seem to recycle parameters: http://www.helmancnc.com/tapered-threading-with-fanuc-g76-threading-cycle/ P, Q and R are used twice in the same two block command. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/ ------------------------------------------------------------------------------ "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE Instantly run your Selenium tests across 300+ browser/OS combos. Get unparalleled scalability from the best Selenium testing platform available Simple to use. Nothing to install. Get started now for free." http://p.sf.net/sfu/SauceLabs _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
