wow - didn't mean to send that.. well to finish my thought - would you put g41.1 at the begining of every part/shape? I could see that working very well.
sam On 10/2/2014 10:26 AM, sam sokolik wrote: > are you saying have a g41.1 on > On 10/2/2014 10:07 AM, Dave Cole wrote: >> On 10/2/2014 10:46 AM, andy pugh wrote: >>> On 2 October 2014 15:40, Dave Cole <[email protected]> wrote: >>>> They would like to be able to adjust the jet size (think tool diameter) >>>> on the fly >>> This is probably most easily done with G42.1 and G41.1, though the >>> G-code would have to actually stop and look for new values from an >>> input source. >>> >>> Any change of tool diameter would require a recalculation of the >>> motion queue, so I don't think that there is any way to do it >>> completely live. >>> As an initial step job-by-job, however, it would be relatively easy. >> So perhaps if I had the tool/jet diameter in a hal float pin, I could >> use that along with the analog input function in Gcode to grab the hal >> value and then assign it via an invocation of G42.1 or G41.1 ? >> >> Does that sound possible/reasonable? >> >> So in this respect the tool table becomes a non issue? Does this sound >> correct? >> >> Thanks, >> >> Dave >> >> --- >> This email is free from viruses and malware because avast! Antivirus >> protection is active. >> http://www.avast.com >> >> >> ------------------------------------------------------------------------------ >> Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer >> Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports >> Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper >> Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer >> http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk >> _______________________________________________ >> Emc-developers mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-developers >> >> > > ------------------------------------------------------------------------------ > Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer > Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports > Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper > Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer > http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > > ------------------------------------------------------------------------------ Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
