As far I know, it is not solved.
See:
http://www.linuxcnc.org/index.php/english/forum/26-turning/29290-lathe-tool-image-not-displayed-rear-tools
Citando Tom Easterday <[email protected]>:
> Does anyone know if this issue was resolved?
> http://emc-developers.narkive.com/OwGHijSh/error-in-backplot-with-backtool-set-up-in-lathes
>
> <http://emc-developers.narkive.com/OwGHijSh/error-in-backplot-with-backtool-set-up-in-lathes>
>
> I am having this problem now that I finally have gotten all the
> planets (nearly) aligned to display my slant bed lathe correctly.
> Everything is working EXCEPT the tool is not displayed in Axis, I
> only have a “+” displayed. Not a show stopper, but would be nice to
> have working correctly. I have seen several discussions like this
> but haven’t found that it was ever resolved…
> Thanks,
> -Tom
>
>
> ------------------------------------------------------------------------------
> Monitor 25 network devices or servers for free with OpManager!
> OpManager is web-based network management software that monitors
> network devices and physical & virtual servers, alerts via email & sms
> for fault. Monitor 25 devices for free with no restriction. Download now
> http://ad.doubleclick.net/ddm/clk/292181274;119417398;o
> _______________________________________________
> Emc-developers mailing list
> [email protected]https://lists.sourceforge.net/lists/listinfo/emc-developers
------------------------------------------------------------------------------
Monitor 25 network devices or servers for free with OpManager!
OpManager is web-based network management software that monitors
network devices and physical & virtual servers, alerts via email & sms
for fault. Monitor 25 devices for free with no restriction. Download now
http://ad.doubleclick.net/ddm/clk/292181274;119417398;o
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
