On 9 October 2015 at 14:06, Jeff Epler <[email protected]> wrote: > I'm not aware of any current project to change this, but it would not be > unwelcome. One challenge is the gcode syntax: how do you specify the > normal to be used? I think many of the other layers of code are > prepared to accept arbitrary arcs, though the preview plots may need > additional modification.
I _think_ that a start, end, and centre point define no more than two candidate arcs for any set of three points. If the interpreter always chose the one with the smallest swept angle then I think that would be unambiguous. Having said that, 3D arcs would be something more easily cmputed by CAM, yet CAM rarely seems to use even 2D arcs. I had assumed that this was aimed at 3D arcs: http://git.linuxcnc.org/gitweb?p=linuxcnc.git;a=shortlog;h=refs/heads/arbitrary-arc Though it hasn't had much recent attention. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
