On Saturday 27 February 2016 14:52:49 Gene Heskett wrote: > On Saturday 27 February 2016 07:30:35 Gene Heskett wrote: > > On Wednesday 24 February 2016 04:49:09 Gene Heskett wrote: > > > > Ping? > > Just for S & G, I took that code, and the tool.tbl, from that machine > to the toy in the shop building, That same version of LCNC, running > w/o home switches, does NOT display this x only artifact in the > backplot. > > I've poked at the options in the view menu without apparent effect. > > Something in the $config? Differences in homing? Obviously I've not > a clue, but its annoying as can be when I am now, due to mistakes I > might have seen were it not doing this, down to 30 of these trim > pieces that IF no more mistakes are made, are exactly the amount I > need to complete this 3 chest project. And there are yet at least 4 > machineing operations I have to do to these things before I'm ready to > glue them into place. I have to cut to length, cut out the back, > leaving the final L shaped piece, and do at least 2 setups with a > roundover tool, one useing a bearing guided cutter, and another > pointed tool to break the sharp edges.
Even More Puzzling. That machine is not now doing it either. I've restarted LCNC but have not done the touch-offs that job would need if setup to be done again. I did do some touch-offs for the next job, but when I reloaded that code again, the display was still good. Did someone sneak in overnite and open up a can of snilmerg spray? I'll get my coat. Sorry for the noise. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
