> wrote: > > > When the machine is doing a spindle synchronized operation such > > > as tapping, this causes the motion sync to be broken as well as the > > > tap! > > > > Does motion.feed-inhibit sound like what you need? > > http://linuxcnc.org/docs/2.7/html/man/man9/motion.9.html > > Butting in here, not sure Andy. It seems to me the ideal situation would > be to just shut the spindle down, while NOT unlocking the axis that was > slaved to it, which might save the tap AND allow hand applied power in > reverse to unscrew the tap from the hole with the machine still > following the tap back out of the hole. The chances of restarting the > operation to finish that hole are somewhere between slim and .00001%
One hole could probably be finnished by hand. > unless the starting point is saved and can be run back to, which I don't > believe is the case now as its forgotten at the end of each run with the > current code anyway, but the tap may be saved. Perhaps this starting > point save might be part of this GSOC G33.1 improvement project? Nicklas Karlsson ------------------------------------------------------------------------------ Transform Data into Opportunity. Accelerate data analysis in your applications with Intel Data Analytics Acceleration Library. Click to learn more. http://pubads.g.doubleclick.net/gampad/clk?id=278785471&iu=/4140 _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
