On 07/01/2017 04:35 PM, Kirk Wallace wrote:
On 07/01/2017 02:33 PM, Les Newell wrote:
I'm in the process of writing a lathe kinematics module. Everything
seems to be mostly working but Axis doesn't show the axis letters for
the DROs. When in joint mode it displays the joint numbers as expected.
In world mode it just shows H for each axis. This is a basic XZ lathe
config. If I use trivkins the axes are shown correctly. Does anyone have
any idea what I'm doing wrong?
Maybe try here, about a third of the way down shows "def draw_axes()" in
glcanon.py:
http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Gremlin
Sometimes the axis letter shows up as a thin line because it is shown on
the edge and it needs to be rotated to face towards the viewer.
Oops, I reread your message and realized that I didn't understand your
question correctly. So, never mind.
--
Kirk Wallace
http://www.wallacecompany.com/machine_shop/
http://www.wallacecompany.com/E45/
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
