Gmoccapy is not the issue, as you can add more digits to the DRO on the
settings page. But if you speak about 0.1 µm it is useless to build a
lathe on that accuracy, as you will never be able to turn a part at that
accuracy. Just a few degrees temperature difference will destroy the
repeatability.
Just calculate 1 Degree is 1 µm length difference on every 100 mm.
Norbert
Am 04.07.2017 um 17:15 schrieb Marius Liebenberg:
The DRO's will have to be modified a bit I suppose. In order to show
the larger travels. The max travel is about 300mm.
------ Original Message ------
From: "andy pugh" <[email protected]>
To: "Marius Liebenberg" <[email protected]>; "EMC developers"
<[email protected]>
Sent: 2017-07-04 13:59:32
Subject: Re: [Emc-developers] Finest resolution of Lcnc
On 4 July 2017 at 12:10, Marius Liebenberg <[email protected]>
wrote:
The question I have is - will I be able to control the lathe to say
0.1
micro meter with Lcnc using the Gmoccapy front end.
You could easily configure the machine to use microns as the base unit
(then G20 would work in thousandths of an inch).
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
