Correct the machine will run between 21 and 23 degrees Celsius always.
------ Original Message ------
From: "Eric Keller" <[email protected]>
To: "Marius Liebenberg" <[email protected]>; "EMC developers"
<[email protected]>
Sent: 2017-07-04 17:29:57
Subject: Re: [Emc-developers] Finest resolution of Lcnc
I work with a machine that displays out to an angstrom iirc. It uses mm
as the main units. That's a lot of digits. I don't think I would want
to work in microns. I know people are trying to hold dimensions on the
order of a nanometer with similar machines. Our machine isn't tuned
quite that well, and you need a temperature controlled environment
On Tue, Jul 4, 2017 at 11:15 AM, Marius Liebenberg
<[email protected]> wrote:
The DRO's will have to be modified a bit I suppose. In order to show
the larger travels. The max travel is about 300mm.
------ Original Message ------
From: "andy pugh" <[email protected]>
To: "Marius Liebenberg" <[email protected]>; "EMC developers"
<[email protected]>
Sent: 2017-07-04 13:59:32
Subject: Re: [Emc-developers] Finest resolution of Lcnc
On 4 July 2017 at 12:10, Marius Liebenberg <[email protected]>
wrote:
The question I have is - will I be able to control the lathe to say
0.1
micro meter with Lcnc using the Gmoccapy front end.
You could easily configure the machine to use microns as the base
unit
(then G20 would work in thousandths of an inch).
--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
