On 09/12/2017 11:37 PM, Kurt Jacobson wrote:
Hello Jon,
It is certainly possible to used PathPilot on non Tormach machines and with
hardware other than mesa. In fact, it is quite strait forward to do so, and
that is coming from a Linux and LinuxCNC newby. As far as I can tell
PathPilot is basically LCNC 2.6 with a very bloated custom interface and
some fancy HAL cobbled onto it, nothing fancy. As long as what your
customer wants to do would work with LCNC 2.6, it should work fine with
PathPilot.
Thanks much for your comments!
We were hit hard by Irma so don't have power or Internet at the moment, but
when that is back I can proved information on how to start up PathPilot
with out it complaining about the missing mesa cards etc. if you or your
client are interested.
Thanks, sorry about the mess with Irma, hope you get
everything back soon. Whenever it is convenient, I'd
appreciate that info. I may have to do some hand holding
for him, or at least try it out here.
Thanks again,
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
