What Chris says is right - if GUI changes are just in the form of VCP and
configs and all, it is fine with me - and thanks for your work!
Moses
On 7/5/19 2:57 PM, Chris Morley wrote:
The release manager has last say on what can't be added.
Assuming your 'GUI' changes are VCP changes (not say AXIS changes) , then it
sounds fine to add.
plasmac is a stand alone component so is fine to add.
If you don't get a negative response from Moses soon, I think you can safely
assume it's ok.
(And since 2.8 isn't released yet we actually could back out code )
Chris M
________________________________
From: Phillip Carter <[email protected]>
Sent: July 5, 2019 4:25 AM
To: linuxcnc-developers
Subject: [Emc-developers] 2.8 plasmac
I have tested the plasmac configurations on 2.8 and they appear to work ok with
the only proviso that the reverse run feature is not supported.
I have modified the GUIs so that none of the reverse run widgets show if the
LinuxCNC version is less than 2.9.
Is it feasible to put plasmac in 2.8?
If so I will then need a bit of guidance on how to do it.
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
--
And as it is appointed unto men once to die, but after this the judgment:
So Christ was once offered to bear the sins of many; and unto them that look for
him shall he appear the second time without sin unto salvation.
(Hebrews 9:27-28)
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
