On Montag, 1. Juni 2020, 01:00:15 CEST andy pugh wrote:
> On Sun, 31 May 2020 at 17:58, Reinhard <reinha...@schwarzrot-design.de>
>>
> > > Which LinuxCNC version?
> > 
> > master from repository.
> 
> Is 2.8 the same? I am wondering if this is related to
> https://github.com/LinuxCNC/linuxcnc/issues/865

Hm, wasn't aware of that entry. 

Yes, looks quite the same. But does not happen everytime.
I always test with master and hit stop on a running job is quite normal.
Sometimes (more often than a hazardous run) I get the Error-Message: "need to 
be enabled, in coord mode for linear move"
... but most times it works just as expected.

Yesterday it was the first time, that I noted that behaviour.
When it happened first, it looked like motion will terminate current command/
segment.
Second time, it looked like motion performs a command, that's not in the file.
So may be random, don't know.


regards Reinhard




_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers

Reply via email to