On Saturday 01 May 2021 09:12:41 Thomas J Powderly wrote: > Hello > here is an esp32 stepgen for linuxcnc > > this snuck under my radar, i missed it by a few months > > it maybe of use > > The example setup was > > laptop > eth > w5500 module > esp32 > stepper drives > stepper motors > > the video shows the linuxCNC logo running and a single closed loop > stepper > > https://www.youtube.com/watch?v=_Goi4YVU0js > > the github has the code > > https://github.com/Deotti-cl/linuxcnc-esp32 > > i haven't looked hard yet > > but i think the comms are really spi > > and so it might hookup to a pi with a very short cable. > > tomp > Looking at the driver, no, its udp over ethernet. > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers
Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
