On 10/14/23 10:17, gene heskett wrote:
On 10/14/23 09:13, Sam Sokolik wrote:
I have actually seen this playing with axis from master on bookworm. At
some point the refresh button in axis just quits working. You have to
physically re-open the gcode file for the changes to show up. Then the
refresh button will work for a bit.
I thought it was just me...
Nope, Sam, that green reload button (axis interface) has been funkity
for quite some time, but seems to have gotten more like tits on a boar
hog lately. At one point yesterday, I tried it, and got different code,
that contained 2 lines I had removed from that file back in September
when I decided to make two different programs out of it instead. This
was a 30 line file, one operation in a while loop. Reloading by
filename(menu->open) was the only way I could get the results I had just
edited into the file, back into lcnc, the menu->reload was also getting
old code. geany launched from the menu->edit.
That really ought to set a flag to do the reload automatically when
geany exits.
I first thought geany was starting to do gedit's 54 pickup tricks but
several subsequent cats of the file were correct but lcnc was reloading
old code.
I just verified this on my sixty40 mill too, I have to use the
menu->open pulldown to get the code I just edited 30 seconds before.
Cheers, Gene Heskett.
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
_______________________________________________
Emc-developers mailing list
Emc-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-developers
