Ah, yes, it's from the moderator section. Here is the direct link:
https://codeberg.org/LinuxCNC/linuxcnc
The 'skynet' repo (and possibly others) have been created by user
grotius for various purposes and are usually in some state of disrepair.
Regards Dave
On 3/26/26 21:26, Bertho Stultiens wrote:
On 3/26/26 8:20 PM, David Mueller wrote:
Apparently a Linuxcnc repo has been setup on codeberg: https://
forum.linuxcnc.org/moderator-forum/58396-linuxcnc-on-codeberg#343204
Forum links gives a 403 error. Only accessible for moderators?
There are several on:
https://codeberg.org/skynet
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
