I have not tried this ISO but I have experienced the kernel version issue Luca mentions when building ISOs Debian Live grabs packages from the version of Debian that is installed on the host computer. Debian 13.5 with kernel 6.12.86 was released on 16 May 2026. Seems like Debian 13.5 is not installed on your host PC so Debian Live gets confused due to the point release mismatch. This kernel conflict will cause errors with any DKMS drivers that are installed. (eg Realtek network drivers and Ethercat- I found out the hard way). You need to do a full upgrade to Debian 13.5 before building the ISO. Rod Webster
On 2026-06-29 11:33, Luca Toniolo <[email protected]> wrote: > I spun up a VM, Live session seems ok, linuxcnc runs, axis opens up, > homes and runs gcode fine. > > But I cannot get DHCP when going trough the installer, it keeps asking > me for a fixed IP, I don't think that is normal. > > Going trought the ISO, the likely issue seems to be the debian-cd / > live-build d-i config pulled netcfg-static (or excluded full netcfg). To > fix you try to rebuild installer with the full netcfg udeb. > > Something that maybe relevant, I noticed two nic-modules udebs present, > stale 6.12.73 + active 6.12.86 > > Luca > > On 6/28/2026 11:33 PM, andy pugh wrote: > > Is anyone able to test the 2.9.9 ISO file? I am away from home and > > don't have a suitable install candidate. > > > > https://www.linuxcnc.org/iso/linuxcnc_2.9.9-amd64.hybrid.iso > > > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
