Hello Dwight, the standards for ESD are IEC 1000-4-2 and EN 61000-4-2. These standards not only state the levels to test with, but also have some graphs showing how to test your equipment, how to set up the surrounding and so on.
Hope this will help, Iris Scheyer ____________________________________________________________ Iris Scheyer Quality Assurance Engineering ELSA AG Sonnenweg 11 Phone: +49-(0)241-606-0 52070 Aachen Fax: +49-(0)241-606-2099 Germany Email: [email protected] ____________________________________________________________ Dwight Hunnicutt <[email protected]> schrieb / wrote am / at : 12.08.98 23:50:10 > Any of you ever get handed the responsibility to deploy an ESD control > system for your engineering group? I'm talking about ESD for our > hardware and test engineers, not the manufacturing folks. > > Just put out the ESD mats and distribute wrist straps, and have a tester > laying around to check straps? I'm sure there is more to it than > that...any good books to read, or websites to plunder? Any US or Euro > standards to follow for the engineering group (per ISO9001) ? > > Dwight > -- > > DWIGHT HUNNICUTT > Sr. Compliance Engineer > > **************************** > * <[email protected]> * > * (510) 413-1349 direct * > * (510) 492-0808 fax * > * VINA Technologies,Inc. * > * 42709 Lawrence Place * > * Fremont, CA 94538 * > **************************** > > --------- > This message is coming from the emc-pstc discussion list. > To cancel your subscription, send mail to [email protected] > with the single line: "unsubscribe emc-pstc" (without the > quotes). For help, send mail to [email protected], > [email protected], or [email protected] (the list > administrators). --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], or [email protected] (the list administrators).
