Dwight, here are some of the standards you were looking for: 1. ANSI/IPC-A-610: Acceptabilityof Electronics Assemblies 2. MIL-STD-1686: Electrostatic Discharge Control Program..... 3. EIA-541: Packaging Material....
You should be able to find all the ESD stuff you need in these three standards. Later. Jim. Dwight Hunnicutt wrote: > Any of you ever get handed the responsibility to deploy an ESD control > system for your engineering group? I'm talking about ESD for our > hardware and test engineers, not the manufacturing folks. > > Just put out the ESD mats and distribute wrist straps, and have a tester > laying around to check straps? I'm sure there is more to it than > that...any good books to read, or websites to plunder? Any US or Euro > standards to follow for the engineering group (per ISO9001) ? > > Dwight > -- > > DWIGHT HUNNICUTT > Sr. Compliance Engineer > > **************************** > * <[email protected]> * > * (510) 413-1349 direct * > * (510) 492-0808 fax * > * VINA Technologies,Inc. * > * 42709 Lawrence Place * > * Fremont, CA 94538 * > **************************** > > --------- > This message is coming from the emc-pstc discussion list. > To cancel your subscription, send mail to [email protected] > with the single line: "unsubscribe emc-pstc" (without the > quotes). For help, send mail to [email protected], > [email protected], or [email protected] (the list > administrators). --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], or [email protected] (the list administrators).
