Hello Leslie, The EN 61000-4-4 (1995) standard says in the endorsement notice: "The text of the International Standard IEC 1000-4-4 (1995) was approved by CENELEC as a European Standard without any modification."
In the foreword to the IEC 1000-4-4 (1995) it says that this standard is based on IEC 801-4 (1988), but the scope of the IEC 1000-4-4 (1995) has been extended to all kinds of electrical and electronic equipment. For this purpose it has bbeen decided to transfer the 801 series of publications to the IEC 1000, part 4 series. It too says: "No technical changes, only editorial amendments have been made with this transfer and reference to IEC 801-4 (1988) or IEC 1000-4-4 is equivalent." As EN 61000-4-4 (1995) is the same as IEC 1000-4-4 (1995) there is no difference between IEC 801-4 (1998) and EN 61000-4-4, in terms of test method, procedures, limit, etc.. Venlig hilsen / Regards Niels Hougaard EMC Engineer, B.Sc.E.E. BARCO Communication Systems - Denmark Web www.barco.com > -----Original Message----- > From: Leslie Bai [SMTP:[email protected]] > Sent: 14. december 1999 03:22 > To: [email protected] > Subject: IEC801-4 (1998) & EN61000-4-4 > > > Hello Group: > > We have a product which was covered under > ETS 300 385 but now EN 300 385. > > About EFT test, ETS 300 385 refers to IEC 801-4 (1988) > but EN 300 385 refers to EN 61000-4-4. > > Has anyone compared these two standards; > IEC 801-4 (1998) and EN61000-4-4, in terms of > test method, procedures, limit, etc...what are the > differences.... > > Thanks, > Leslie --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], [email protected], or [email protected] (the list administrators).
