Great point Dave.  This and paragraph 15.29 are found under Subpart A -
General.  In my book, they're on page 615 and 619.
Dan Kinney
Horner APG

> -----Original Message-----
> From: David Spencer [SMTP:[email protected]]
> Sent: Wednesday, November 01, 2000 7:25 PM
> To:   'Grant, Tania (Tania)'; 'Dan Kinney (A)'; [email protected]
> Subject:      RE: FCC Part 15 exempted devices
> 
> Hi Tania, Dan, and Group,
> 
> Your quote brought up a nagging little question I had last time I was
> reading through part 15 in this section (I was looking for requirements
> relating to test equipment manufacturers...there are none) regarding the
> reference to section 15.5.  Where is it or where did it go?  My version of
> the CFR doesn't contain a 15.5, as it stops at section 15.407 in section
> E.
> Does anyone know if this is a typo or to what it refers?
> Thanks,
> Dave Spencer
> Oresis Communications
> 
> -----Original Message-----
> From: Grant, Tania (Tania) [mailto:[email protected]]
> Sent: Wednesday, November 01, 2000 1:56 PM
> To: 'Dan Kinney (A)'; [email protected]
> Subject: RE: FCC Part 15 exempted devices
> Importance: High
> 
> 
> 
> Dan,
> 
> (For lack of a comma, they hung a guy.)   I actually checked to be sure
> that
> there is no comma in paragraph (b), since you could have inadvertently
> omitted it.   There is no comma.   Therefore......
> 
> ... your paragraphs b) and c) apply; however, I don't agree with your use
> of
> "only" at the end of your paragraph b).    
> 
> Thus, digital electronic control devices and power systems used
> exclusively
> by a public utility, or the same devices and power systems used
> exclusively
> in an industrial plant are exempt from Rules Part 15, except for the
> general
> conditions of operation in 15.5 and 15.29.  (Thou shalt not emit; and if
> thou emits, thou will provide units for FCC inspection, and thou will
> cease
> operation.)
> 
> 
> Thus, thou is exempt up to a point.
> 
> Tania Grant,  [email protected]
> Lucent Technologies, Switching Solutions Group
> Intelligent Network and Messaging Solutions
> 
> 
> -----Original Message-----
> From: Dan Kinney (A) [ mailto:[email protected]
> <mailto:[email protected]> ]
> Sent: Wednesday, November 01, 2000 12:41 PM
> To: [email protected]
> Subject: FCC Part 15 exempted devices
> 
> 
> 
> I need help with interpretation of one paragraph in FCC Part 15.  I have
> the
> 1 Oct 97 version.  Paragraph 15.103 (b) says a digital device is exempted
> from Part 15 if it is "used exclusively as an electronic control or power
> system utilized by a public utility or in an industrial plant."  One could
> interpret this several ways to include:
> 
> A digital device is exempted if it is used exclusively as:
> 1) an electronic control
> 2) an electronic control utilized by a public utility only
> 3) an electronic control utilized in an industrial plant
> 
> The first interpretation is pretty broad and would exclude a lot of
> equipment.  The third interpretation is broad but causes the manufacturer
> of
> control equipment to somehow make certain his products do not end up in
> use
> anywhere except in an industrial plant.  The second interpretation is
> narrow
> and might be the real intent of this exemption.
> 
> I would appreciate any advice on how any of you would interpret this.
> Thanks in advance.
> Dan Kinney
> Horner APG
> 
> 
> 
> -------------------------------------------
> This message is from the IEEE EMC Society Product Safety
> Technical Committee emc-pstc discussion list.
> 
> To cancel your subscription, send mail to:
>      [email protected]
> with the single line:
>      unsubscribe emc-pstc
> 
> For help, send mail to the list administrators:
>      Jim Bacher:              [email protected]
>      Michael Garretson:        [email protected]
> 
> For policy questions, send mail to:
>      Richard Nute:           [email protected]
> 
> 
> 
> 
> -------------------------------------------
> This message is from the IEEE EMC Society Product Safety
> Technical Committee emc-pstc discussion list.
> 
> To cancel your subscription, send mail to:
>      [email protected]
> with the single line:
>      unsubscribe emc-pstc
> 
> For help, send mail to the list administrators:
>      Jim Bacher:              [email protected]
>      Michael Garretson:        [email protected]
> 
> For policy questions, send mail to:
>      Richard Nute:           [email protected]

-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.

To cancel your subscription, send mail to:
     [email protected]
with the single line:
     unsubscribe emc-pstc

For help, send mail to the list administrators:
     Jim Bacher:              [email protected]
     Michael Garretson:        [email protected]

For policy questions, send mail to:
     Richard Nute:           [email protected]

Reply via email to