Hello group Having only ever dealt with Class II double insulated products, we are going to produce a Class I earthed product. We have an M4 stud in the baseplate and I have to spec the method of connecting the stud to the IEC mains inlet to provide chassis bonding to earth.
I was going to suggest the following "stack" of parts: M4 crinkle washer, M4 solder terminal, M4 crinkle washer, M4 Nyloc nut. Does anyone think that this might prove unsuitable? Regards Chris Colgan EMC & Safety > TAG McLaren Audio Ltd The Summit, Latham Road Huntingdon, Cambs, PE29 6ZU United Kingdom > * Phone: +44 (0)1480 415627 > * Fax: +44 (0)1480 415689 > * Mailto:[email protected] > * http://www.tagmclarenaudio.com > ************************************************************** Please visit us at www.tagmclarenaudio.com ************************************************************** The contents of this E-mail are confidential and for the exclusive use of the intended recipient. If you receive this E-mail in error, please delete it from your system immediately and notify us either by E-mail, telephone or fax. You should not copy, forward or otherwise disclose the content of the E-mail. TAG McLaren Audio Ltd The Summit, 11 Latham Road Huntingdon, Cambs, PE29 6ZU Telephone : 01480 415600 (+44 1480 415600) Facsimile : 01480 52159 (+44 1480 52159) ************************************************************** Please visit us at www.tagmclarenaudio.com ************************************************************** ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
