> Question for the group - Does anyone know of a commercially > available reducer or bushing that we could provide with the unit that > would reduce hole size from 1-1/8 to 7/8 in. diameter?
Since I haven't seen anyone else reply, I'll recommend a company we've bought from, though as they're in the UK the recommendation might not be too helpful. Peppers Cable Glands (www.peppers.co.uk) do hundreds of adaptors/reducers as well as glands, stoppers and various accessories. They come in brass, stainless, nylon, plated mild steel and aluminium... they have (European) approvals for use in hazardous areas as well. Their catalogue seems to have just about every metric, imperial and PG thread size listed - in particular there's a "male thread 3/4" pipe" to "female thread 1/2" pipe" reducer for instance. Might be worth getting in touch, even if they can't help someone in Ohio directly they may know of a States side company in the same business. Regards, Mark -- Mark Hone Wellman CJB Limited Email: [email protected] Airport Service Road Tel: +44 (0)2392 629239 (Direct) Portsmouth, Hampshire Tel: +44 (0)2392 664911 PO3 5PG, ENGLAND Fax: +44 (0)2392 697864 ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
