Hello All,
I have been asked by one of our design engineers if I can measure the RF
signature on the 3v plane on one of our PCB designs. The purpose of this is
to compare it to proposed changes for cost reduction, ie removal of bypass
caps. I would assume I need some sort of CDN but I have no designs for this
application. Does anyone have any ideas on how I can safely probe a 3v DC
power rail with an EMC analyser (HP8591E)?
Regards,
Cameron O'Phee.
EMC & Safety Precompliance.
Aristocrat Technologies Australia.
Telephone : +61 2 9697 4420
Facsimile : +61 2 9663 1412
Mobile : 0418 464 016
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
