I'm looking through Bellcore GR-1089 Issue 2 Revision 1 for details on the test setup for conducted emissions testing.
I was under the impression that some of the measurements involved use of large RF bypass caps to ground, and the interference currents through the capacitor were measured. While I found spec limits and test setups for current probe-style measurements, all the figures simply display a power input network marked 'LISN', which I assume to be the standard 50 ohm network. I can't find a reference that explicitly discusses the use of an RF bypass cap. Could someone point me to the appropriate section? ---- Patrick Lawler [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
