ASTM has Manual 20(see ASTM. http://www.ASTM.org ) Richard Haynes 609 497-4584
-----Original Message----- From: Mel Pedersen <[email protected]> To: '[email protected]' <[email protected]>; [email protected] <[email protected]>; [email protected] <[email protected]> List-Post: [email protected] Date: Wednesday, May 03, 2000 3:01 PM Subject: RE: Corrosion standards > >Also: > >MIL-STD-202F > >- Method 101D: Salt Spray (corrosion) >- Method 106F: Moisture Resistance > >These are probably very similar to the IEC standards referenced below. > >Hope this helps, > >Mel Pedersen (mailto:[email protected] > > > > >-----Original Message----- >From: [email protected] [mailto:[email protected]] >Sent: Wednesday, May 03, 2000 9:50 AM >To: [email protected]; [email protected] >Subject: RE: Corrosion standards > > > > IEC 60068 has many environmental tests. Examples: > Damp heat, cyclic - 60068-2-30 > Sulfur dioxide - 60068-2-42 > Salt mist - 60068-2-52 > You can probably match these tests to NEMA. > David > > >______________________________ Reply Separator >_________________________________ >Subject: Corrosion standards >Author: "[email protected]" <SMTP:[email protected]> at >ADEMCONET >Date: 5/3/2000 7:13 AM > > >Other than NEMA 4X corrosion test (200 hour, 5% salt fog), are there other >expected corrosion specs for equipment used offshore? > >Are any of the NACE standards typically expected for offshore use? By >offshore >I mean oil type rigs and such. > >Thanks > >[email protected] > > > > >------------------------------------------- >This message is from the IEEE EMC Society Product Safety >Technical Committee emc-pstc discussion list. > >To cancel your subscription, send mail to: > [email protected] >with the single line: > unsubscribe emc-pstc > >For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > >For policy questions, send mail to: > Richard Nute: [email protected] > > >------------------------------------------- >This message is from the IEEE EMC Society Product Safety >Technical Committee emc-pstc discussion list. > >To cancel your subscription, send mail to: > [email protected] >with the single line: > unsubscribe emc-pstc > >For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > >For policy questions, send mail to: > Richard Nute: [email protected] > > > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
