forwarded for Helge.... ____________________Reply Separator____________________ Subject: EMC vs. Exi equipment -Svar Author: Helge Knudsen <[email protected]> List-Post: [email protected] Date: 5/11/00 1:23 PM
Hello Amund and Group, If a product standard, i.e. EN 55024/CISPR 24, specifies surge test, this test shall be done if complience with the standard are required. Renember to use 42 ohms generator impedance when testing on signal leads unless other value is specified in the used product standard. Best regards Helge Knudsen Jyske EMC Denmark >>> "Westin, Amund" <[email protected]> 11-05-00 10.15 >>> Hello members, One question, what's common practise regarding surge test (EN61000-4-5 on signal lines) on lines which contains zener barriers ? Have a feeling that the surge test is not applicable..... Comments ? Best regards Amund Westin Det Norske Veritas * [email protected] ********************************************************************** Neither the confidentiality nor the integrity of this message can be guaranteed following transmission on the Internet. This message has been swept by MAILsweeper at DNV for the presence of computer viruses. ********************************************************************** ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
