I too have a problem with application of DOC or DOI. We produce Programmable Logic Controllers and associated Input/Output cards. I've been told I should use the DOI since the PLC will be incorporated into some larger machine that it will control and that the I/O cards will be incorporated into the PLC. But we sell our goods as independent products. In the limited amount of literature I've read, I find no mention of a DOI and none mentioned in the Directives and Standards we use. Can someone direct me to a source document that spells out the difference? Should I use a DOC or a DOI?
Sincerely, Daniel C. Kinney Lead Qualification Engineer Horner APG, LLC Advanced Products Group 640 N. Sherman Drive Indianapolis, IN 46201 Phone: (317) 916-4274 ext. 462 FAX: (317) 916-4287 Email: [email protected] Website: http://www.heapg.com > -----Original Message----- > From: Lacey,Scott [SMTP:[email protected]] > Sent: Friday, March 24, 2000 12:47 PM > To: 'Russell, Ray' > Cc: '[email protected]' > Subject: RE: EMC - Declaration of Incorporation? > > > Ray, > The answer depends on whether your compressor is a component or a finished > product. Component = yes, product = no way. > > Scott Lacey > > -----Original Message----- > From: Russell, Ray [SMTP:[email protected]] > Sent: Friday, March 24, 2000 10:14 AM > To: 'IEEE PSTC' > Subject: EMC - Declaration of Incorporation? > > > Greetings, > > We sell an air compressor with a DC motor. This motor requires a > capacitor > across the DC supply lines to meet the EMC requirements. Of course > management does not want to supply the capacitor, they want to > describe it > in the documentation, and add a note on the Declaration of > Conformity that a > capacitor is required. Is this acceptable for European customers? > > In that scenario, I would like to issue a Declaration of > Incorporation, but > after reviewing the directives, I can only find a reference to the > Declaration of Incorporation in the Machinery Directive. Can this be > used > for the other directives? > > Thank you once again for your assistance, > > > Ray Russell > Regulatory Compliance Engineer > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
