Hello Barry,
you might check IEC 60851-5 (Test methods for winding wires) where Clause
4, (Test 13) uses the metal shot when determining breakdown voltages of a
twisted winding wire.
This test is also referenced in IEC 60950 Annex U.2.1.
mit freundlichen Gruessen/ best regards
Volker Gasse
IBM Germany, Technical Relations/Product Safety,
Tel: +49-7031-642-6796, Fax: -6916, e-mail: [email protected]
Mail: D3114/7103-91, D-70548 Stuttgart, Germany
"barrym" <[email protected]> on 16.03.2000 22:26:37
Please respond to "barrym" <[email protected]>
I'm looking for reference to any standard which may provide specifics for
using lead shot for dielectric strength testing. I know this done for
insulation system qualifications, just have not identified a standard for
the test set up.
Thanks,
Barry Marks
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
