Insulation resistance tests would apply only to IEC 950 I believe, so this may not apply for you ?
Art Michael wrote: > Hello Martin, > > I don't have the answer to your question, but do caution that the First > Test to be run (if the DUT is grounded) is the Ground Continuity Test (for > test-operator protection). > > Regards, Art Michael > > * * * * * * * * * * * * * * * * * * * * * * > * International Product Safety Bookshop * > * Check out our current offerings! * > * <http://www.safetylink.com/bookshop.html> * > * * > * Now offering BSI's Books & Reports * > * including, "World Electricity Supplies" * > * * > * Another service of the Safety Link * > * <www.safetylink.com> * > * * * * * * * * * * * * * * * * * * * * * * > ---------------------------------------------------------------------- > > On Thu, 16 Mar 2000, Martin Rowe (TMW) wrote: > > > > > Group, > > > > A reader asked about the order of performing safety tests. > > Should he perform insulation resistance tests before or after > > hipot tests? The reader didn't say what type of product he's > > testing, but I can ask. > > > > Thanks, > > > > ---------------------------- /\ > > | Martin Rowe | / \ > > | Senior Technical Editor | / \ /\ > > | Test & Measurement World | / \ / \ /\ ____ > > | voice 617-558-4426 |/ \ / \ / \/ > > | fax 617-928-4426 | \ / \/ > > | e-mail [email protected] | \ / > > | http://www.tmworld.com | \/ > > ---------------------------- > > > > > > ------------------------------------------- > > This message is from the IEEE EMC Society Product Safety > > Technical Committee emc-pstc discussion list. > > > > To cancel your subscription, send mail to: > > [email protected] > > with the single line: > > unsubscribe emc-pstc > > > > For help, send mail to the list administrators: > > Jim Bacher: [email protected] > > Michael Garretson: [email protected] > > > > For policy questions, send mail to: > > Richard Nute: [email protected] > > > > > > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
