Ed,
Not a problem with my relatives - they never pay for anything!
Gary
-----Original Message-----
From: Price, Ed [mailto:[email protected]]
Sent: Thursday, June 21, 2001 3:54 PM
To: 'Doug McKean'; EMC-PSTC Discussion Group
Subject: RE: FCC + FCC = FCC? - Outlaw
I hesitate only a bit in adding my opinion here, <grin> as I'm a known
possessor of amplifiers that exhibit gain at 27 MHz and receivers which can
tune the 900 MHz region.
I think that you can build a device for your own use (as earlier defined),
even up to the official 5 devices, but you get on very infirm ground when
you SELL them (even at cost), even to your relatives.
Regards,
Ed
Ed Price
[email protected]
Electromagnetic Compatibility Lab
Cubic Defense Systems
San Diego, CA USA
858-505-2780 (Voice)
858-505-1583 (Fax)
Military & Avionics EMC Services Is Our Specialty
Shake-Bake-Shock - Metrology - Reliability Analysis
>-----Original Message-----
>From: Doug McKean [mailto:[email protected]]
>Sent: Thursday, June 21, 2001 12:11 PM
>To: EMC-PSTC Discussion Group
>Subject: Re: FCC + FCC = FCC? - Outlaw
>
>
>
>Decide among yourselves who of you are outlaws ...
>
>" TITLE 47--TELECOMMUNICATION
> CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION
> PART 15--RADIO FREQUENCY DEVICES--Table of Contents
> Subpart A--General
> Sec. 15.23 Home-built devices.
>
> (a) Equipment authorization is not required for devices that are not
> marketed, are not constructed from a kit, and are built in
>quantities
> of five or less for personal use.
>
> (b) It is recognized that the individual builder of home-built
> equipment may not possess the means to perform the measurements
> for determining compliance with the regulations. In this case,
>the
> builder is expected to employ good engineering practices to
>meet
> the specified technical standards to the greatest extent
>practicable.
> The provisions of Sec. 15.5 apply to this equipment.
>..."
>
>- Doug McKean
>
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Michael Garretson: [email protected]
Dave Heald [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://www.rcic.com/ click on "Virtual Conference Hall,"
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Michael Garretson: [email protected]
Dave Heald [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://www.rcic.com/ click on "Virtual Conference Hall,"
