Hello Steve and All,
For your case (Verification Class A Digital Device) please be advised as
follows:
1. The statement " This device ... undesired operation" needs to be placed
on the product. If the product is too small, you may place it in:
a. The User Instruction Manual
b. The pamphlet supplied to the user
c. The container in which the product is marketed
(See Section 15.10.(5).)
2. The other statement needs to be placed in the User Manual (See Section
15.105).
Regards
Shaike Raz
EMC Laboratory Manager
EMC Laboratory
ITL (Product Testing) Ltd.
Kfar Bin Nun
Israel
Tel: +972-8-9797799
Fax: +972-8-9797702
Email: [email protected]
-----Original Message-----
From: Peter Merguerian [mailto:[email protected]]
Sent: Wednesday, March 14, 2001 7:12 PM
To: 'Steve Austin'; emc pstc
Cc: Shaike Raz
Subject: RE: FCC labels
Steve and All,
I would assume that if your unit is small enough so as not to be able to
have all the wording, you could get an authorization from the FCC. Please
confirm.
Peter Merguerian
Managing Director
Product Testing Division
I.T.L. (Product Testing) Ltd.
Hacharoshet 26, POB 211
Or Yehuda 60251, Israel
Tel: 972-3-5339022 Fax: 972-3-5339019
e-mail: [email protected] <mailto:[email protected]:>
website: http://www.itl.co.il <http://www.itl.co.il/>
TO LEARN ABOUT AUSTRALIAN AND NEW ZEALAND REQUIREMENTS, CONTACT ME AT THE
EARLIEST STAGES OF YOUR DESIGN; REQUIREMENTS CAN BE TRICKY!
-----Original Message-----
From: Steve Austin [mailto:[email protected]]
Sent: Wednesday, March 14, 2001 2:27 PM
To: emc pstc
Subject: FCC labels
Using the FCC "verification" procedure for a Class A digital device, does
the label on the unit have to contain the complete statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
or will This device complies with part 15 of the FCC Rules. be acceptable.
I understand that the following statement must be shown in the documentation
supplied with the unit.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense
Regards
Steve Austin
CASS Industries Limited
austin @cassindustries.com
