Steve,
Here is the pertinent information out of CFR 47. The missing paragraphs
talk about other types of devices and their markings, but you can look the
whole thing up at
http://www.rcic.com/reg/fcc/clauses/15.19.htm
<http://www.rcic.com/reg/fcc/clauses/15.19.htm> (and a thanks to the RCIC
group).
Gary
It does appear that you might gain a little room because the FCC logo and
tested to meet office and home tag line are not required.
Sec. 15.19 Labelling requirements.
(a) In addition to the requirements in part 2 of this chapter, a
device subject to certification, notification, or verification shall be
labelled as follows:.
(3) All other devices shall bear the following statement in a
conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
-----Original Message-----
From: Steve Austin [mailto:[email protected]]
Sent: Wednesday, March 14, 2001 4:27 AM
To: emc pstc
Subject: FCC labels
Using the FCC "verification" procedure for a Class A digital device, does
the label on the unit have to contain the complete statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
or will This device complies with part 15 of the FCC Rules. be acceptable.
I understand that the following statement must be shown in the documentation
supplied with the unit.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense
Regards
Steve Austin
CASS Industries Limited
austin @cassindustries.com
