Clause 8 indicates that the field strength shall be checked by placing the field sensor at a calibration grid point . . .
We have had a bad cable before. This is one way to be sure that every element -- generator, directional coupler, cables, power amplifier and antenna are connected correctly and functioning properly. Besides being called for in the standard, it is a good practice. Best regards, Don Umbdenstock Sensormatic > ---------- > From: > [email protected][SMTP:[email protected]] > Reply To: [email protected] > Sent: Monday, January 29, 2001 4:28 PM > To: [email protected]; '[email protected]' > Subject: question about EN61000-4-3 > > > forwarding for [email protected] > > ____________________Reply Separator____________________ > Subject: > Author: [email protected] > Date: 1/29/01 11:57 AM > > Hello group, > > I have a question about EN61000-4-3. Specifically about field uniformity > calibration procedure. Is it requirement to document level of forward > power > using directional coupler connected to antenna or is it enough to record > drive level of signal generator. > > Any comments would be welcomed. > > Thanks, > > > S. Lisinker > EMC department > SANMINA. > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
