Gentlemen Assuming a Win-Tel platform, I have found that both Excel and/or Access to be adequate for large databases that will not have more than (2) users. The caveat is that all embedded VBA source be mapped in a separate (formal) document, and that the Network Admin carefully controls privileges and provides routine back-up services. ISO and agency auditors have accepted tracibility provided by these methods.
Brian -----Original Message----- From: Andrew Carson [mailto:[email protected]] Sent: Monday, April 15, 2002 9:22 AM To: [email protected]; [email protected] Subject: RE: Calibration Tracking Software We use a package called GAGEtrack, produced by the CyberMetrics Corporation. www.visit.com Good if you have a large number of items to track and control. If you only have a limited number, Excel is a very good tool. Andrew Carson - Senior Compliance Engineer, Xyratex, UK Phone: +44 (0)23 9249 6855 Fax: +44 (0)23 9249 6014 -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: 15 April 2002 15:37 To: [email protected] Subject: RE: Calibration Tracking Software Mike, we use Excel and include the following data: Model Description Serial number Manufacturer Last cal date Due cal date Calibration lab Cal cost Richard Woods Sensormatic Electronics Tyco International -----Original Message----- From: Mike Stone [mailto:[email protected]] Sent: Monday, April 15, 2002 8:22 AM To: EMC-PSTC (E-mail) Subject: Calibration Tracking Software Good Morning, I have been looking for a reasonably priced (cheap) software program to track and produce status reports for our calibrated equipment. Does anyone have any suggestions? Thank you in advance. Regards, Michael Stone L. S. Compliance Inc. W66 N220 Commerce Court Cedarburg, WI 53012 262-375-4400 Ext. 128 [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
