Inject between each line and ground plane. You can inject line-to-line but if you pass the others you will surely pass across the bulk cap.
---------- >From: "Vuylsteke, Peter" <[email protected]> >To: "'[email protected]'" <[email protected]> >Subject: CS06 of MIL-STD461D >Date: Sat, Aug 24, 2002, 2:30 AM > > > Hi group, > > A customer is requesting us to test our primary 28Vdc lines according to the > CS06 test of the Mil-std 461B. Our primary 28Vdc has a 28V High line and an > ungrounded 28V Low line. It is decoupled from our secondary electrical > ground (GND) by means of a transformer. The GND is connected to the chassis > via one starpoint in the unit. > I have read the procedure in the Mil-461B and the Mil-462 and have seen that > we need to perform a parallell injection of the pulse on the lines. My > problem is between which lines does the Mil-std mean? Does it mean to > inject the pulse between the 28V High line and the 28V Low line or do I need > to inject the pulse between the 28VHigh line and GND and between the 28VLow > line and GND. > Or am I missing the clue of the CS06 test? > > Thanks > Peter > > > --------------------------------------- > Peter Vuylsteke > > BarcoView > dept. Avionics > Hardware Development Engineer > > Barco mailto:[email protected] > tel: +32 (0)56 23 30 84 > fax: +32 (0)56 23 35 88 > Visit our site: http://www.barco.com > >> -------------------------------------------------------------------------- >> -------------- >> The information contained in this message is confidential and may be >> legally privileged. >> The message is intended solely for the addressee(s), If you are not the >> intended recipient, >> you are hereby notified that any use, dissemination, or reproduction is >> strictly prohibited >> and may be unlawful. If you are not the intended recipient please contact >> the sender by >> return e-mail and destroy all copies of the original message. >> >> >> >> > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Ron Pickard: [email protected] > Dave Heald: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > Jim Bacher: [email protected] > > All emc-pstc postings are archived and searchable on the web at: > http://ieeepstc.mindcruiser.com/ > Click on "browse" and then "emc-pstc mailing list" > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
