How about the usual method of determining the value of very low resistances and impedances? Pass a known (relatively high) AC current through the connection, measure the voltage drop and use Ohm's law to calculate the resistance (and this is, after all, an essentially resistive connection).
Bob Wilson TIR Systems Ltd. Vancouver. -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: April 15, 2002 4:49 AM To: [email protected] Subject: question on measuring bonding impedance Is there a standard method for measuring AC bonding impedances for electrical bonding? Thanks in advance, Susan Beard ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
