I am sure you also addressed this but since I have 2 cents to add....... A front-end overload condition on the receiver/analyzer, or an overload at the pre-amplifier, can cause errors in measurement that may seem transparent. A local transmitter could be overloading your measurement system and increasing your emissions readings....
Again, take it at what it is worth! (2 cents) Randy Flinders Senior Compliance Engineer Emulex Corporation - We Network Storage 3535 Harbor Blvd. Costa Mesa, Ca. 92626 Direct: (714) 513-8012 Fax: (714) 513-8265 Email: [email protected] <mailto:[email protected]> Web: <http://www.emulex.com> From: drcuthbert [mailto:[email protected]] Sent: Tuesday, March 25, 2003 2:31 PM To: '[email protected]'; '[email protected]' Subject: PC EMI Derrick, I'm sure you used the antenna factors correctly but I'll put in my 2 cents worth anyway. Were the AF's used correctly? You need the TX AF and the RX AF. If the receive antenna factor was used as the transmit antenna factor that will skew the calibration. Dave Cuthbert This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
