Zohar, Put a jumper wire or connector in series with suppressors, allowing you to conduct Hi-Pot Test on the unit without stressing any of these components. The connection is resumed after placing jumper back on the board; unit shall not be able to operate without the jumper.
Best Regards, Leszek M. Langiewicz Sr. Compliance Eng. / Homologation Phogenix Imaging, LLC A joint venture of Kodak and HP Phogenix Imaging LLC 16275 Technology Dr. San Diego, CA 92127-1815 www.phogenix.com (858) 798-8004 : (858) 722-8004 (858) 798-8113 : [email protected] From: [email protected] [mailto:[email protected]] Sent: Monday, May 12, 2003 2:58 AM To: [email protected] Subject: Production Line Hi-Pot Test Dear Grope We have designed an AC/DC converter constructed in the primary side with two varistors (rated 275V), one side of one of them connect to Line , other side connected to Earth through Gas Tube, second varistor one side connected to Neutral and other side to Earth trough the same Gas Tube. My question is how to conduct the production line Hi-Pot test ? It's unpractical to remove those components before testing in production !! Thanks Zohar This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
