There is a new document in the works, IEC 61000-4-34, for dip & interrupt testing of products drawing greater than 16A. It is currently a CD (Committee Draft). TC77A WG6, who is responsible for this document, meets in Spain in September, after which a CDV (Committee Draft for Vote) is possible. It is essentially the same as the 2nd revision of IEC 61000-4-11, now in the CDV stage. This revision will also be dealt with at the September meeting.
Best Regards, Michael Hopkins Manager, EMC Technologies Thermo Electron Control Technology Division EMC & ESD Simulation Solutions One Lowell Research Center Lowell, MA 01852 Tel: +1 978 275 0800 ext. 334 Fax: +1 978 275 0850 [email protected] One Thermo, committed to integrity, intensity, innovation & involvement From: Paolo Peruzzi [mailto:[email protected]] Sent: Tuesday, July 22, 2003 6:45 AM To: [email protected] Subject: voltage dips Hi all, Is there any basic standard concerning voltage dips and short interruptions immunity for equipment with input current larger than 16 amps per phase? And more: can a product standard prescribe such test for equipment with more than 16 amps per phase and still refer to 61000-4-11 as basic standard? Thanks, Paolo Peruzzi Esaote S.p.A. Research & Product Development - Design Quality Control via di Caciolle, 15 I- 50127 Florence tel: +39 055 4229469 fax: +39 055 4223305 e-mail: [email protected] This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
