I read in !emc-pstc that Ron Pickard <[email protected]> wrote (in <of61ccbfa0.b1a471b8-on07256e8a.0075139e-07256e8a.0077b...@hypercom.com> ) about 'What does the CE mark mean for EMC' on Tue, 4 May 2004:
>EN55024 itself sets limits and provides references >to the IEC61000-4-x (not EN61000-4-x) No. Look at Annex ZA of these ENs to see that the IEC standards referenced in Clause 2 of the standard are replaced by the ENs listed in the Annex. This is IMPORTANT, because the relationship is NOT necessarily 1:1, although it often is. > basic standards. The IEC/EN 61000-4-x >standards provide >guidance on how to perform the testing sets limits, No, they don't set limits. They **appear** to, but this part of each Basic Standard is not valid and will be removed or re-worded in later editions. -- Regards, John Woodgate, OOO - Own Opinions Only. The good news is that nothing is compulsory. The bad news is that everything is prohibited. http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ieee-pses.org/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
