Agreed... The requirements vary from one agency to the next. Suggest examining CIG 022 and CIG 023 forms...they cover a lot of ground common to most certifiers. Might also contact the NRTL in request of copy of their audit form to ensure all bases are addressed. NRTL's are usually pretty good about teaming with clients these days. Product audit might also be required.
Regards, Kaz From: [email protected] [mailto:[email protected]] On Behalf Of Brian O'Connell Sent: Friday, June 17, 2005 4:27 PM To: Arthur Michael; [email protected] Subject: RE: NRTL IPI Checklist??? Most NRTLs will provide an audit "checklist" upon request. I can think of several immediate sources. The basic mfr's requirements can be found in the Section General of your UL FUS reports, CSA Design Guide for that standard, or perhaps an agency's IEC 17025 audit form (but the latter would be more appropriate for the company's test lab than the factory). Also, whatever agreement was signed between the mfr and the agency will state the min factory requirements. luck, Brian > -----Original Message----- > From: [email protected] > [mailto:[email protected]]On Behalf > Of Arthur Michael > Sent: Friday, June 17, 2005 1:15 PM > To: [email protected] > Subject: NRTL IPI Checklist??? > > Hello all, > > Can anyone share a written checklist for use by a newbie in > the compliance > business (not me :-), faced with their first interaction > with a NRTL's IPI > (Initial Production Inspection). > > I've been thru it a number of times over the years myself, > but have never > see a written procedure. Their interest is in a generic > checklist of items > of concern during the IPI. Time is short (what's new about > that?), and we > are trying to anticipate any and all concerns prior to the IPI. > > Obviously all items in the Report must be supported > (conformance-wise) but > we won't have the report until a few days before the IPI, further > supporting the need for advanced-knowledge prior to the IPI. > > The newbie is in China (information only). The product is > under UL 588, > Seasonal Decorative Products and consists primarily of a fan motor > assembly and some light bulbs and sockets. No hi-tech here! This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/listserv/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/listserv/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
