Hi All, I have a couple of questions related to EN/IEC 61010-1 requirements.
1) With regards to fire enclosures there is a limit for hole sizes in bottom of appartus casing, f.ex. 2mm diameter with 3mm between centers. Now if we make square holes is it then allowed to make them also 2x2mm with 3mm center spacing or must they be designed like the requirements for a mesh ? 2) Are there any other requirements besides isolation voltage and creepage distances, to transformes used for LAN interface in 61010-1 equipment ? Best regards PBI-Dansensor Peter Weichel Test and Approval Engineer PBI-Dansensor A/S Roennedevej 18 DK-4100 Ringsted Tel.: (+45) 57 66 00 88 Fax: (+45) 57 66 00 99 e-mail: [email protected] Website: www.pbi-dansensor.com CONFIDENTIALITY. This email and any attachments are confidential and may also be privileged. If you are not the named recipient, please notify the sender immediately and do not disclose the contents to another person, use it for any purpose or store or copy the information in any medium. - This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
