Grace, Not sure if you have had any response concerning Australia & New Zealand. Only the 2.4 is OK for NZ. So for Aust & NZ the situation is: - 418 MHz not allowed in Australia or NZ; - 433.92 allowed in Aust but not in NZ (NZ only allow "Telemetry/Telecommand" devices to operate on this frequency under the SRD general user licence); and - 2.4 GHz allowed in both Aust & NZ
Best regards, Kevin Richardson Stanimore Pty Limited Compliance Advice & Solutions for Technology (Legislation/Regulations/Standards/Australian Agent Services) Ph: 02-4329-4070 (Int'l: +61-2-4329-4070) Fax: 02-4328-5639 (Int'l: +61-2-4328-5639) Mobile: 04-1224-1620 (Int'l: +61-4-1224-1620) Email: [email protected] URL: www.stanimore.com This material (this message and the information contained in all attachments to this message) is confidential and/or privileged information and is intended only for the addressee/s named above. Any unauthorised dissemination, copying, use of or reliance upon this material by persons or entities other than the addressee/s named above is prohibited. If you receive this material in error, please notify Stanimore Pty Limited and destroy all copies (electronic and hardcopy) of this message and all attachments immediately. From: [email protected] [mailto:[email protected]]On Behalf Of Grace Lin Sent: Tuesday, 23 May 2006 9:56 PM To: [email protected] Subject: Re: Frequency Acceptance in Countries Dear All, Thank you very much to those who have replied to my questions. You made my job much easier. Special thanks to Karin Silbertorn of CETECOM who has been patient to answer my questions and explained terminologies used in frequency allocation tables. In addition, I would like to give my thanks to all administrators who help us to communicate with each other. Best regards, Grace On 5/17/06, Grace Lin <[email protected]> wrote: Dear Group Members, Can group members help me to prepare a chart of frequencies that accepted by various countries? Frequencies interested are 418MHz (short range devices, handheld remote controllers), 433.92MHz (short range devices, handheld remote controllers), and 2.4GHz ( 2.400-2.4835GHz) spread spectrum devices. At this time, countries interested include: * Australia * Canada * EU (Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Norway, Portugal, Spain, Sweden, Switzerland, The Netherlands, UK) * Japan * New Zealand * US Following is where I am after a couple of days Internet research. Please correct me if I am wrong. For 2.4GHz, all listed countries accept this frequency except France (only accepts 2.4465-2.4835MHz) and Japan (only accepts 2.471-2.497GHz). For 433.92MHz, all listed countries accept this frequency except Greece and Norway. For 418MHz, this is a tough one. Canada and US accept this frequency. UK accepts this frequency before December 31, 2007. I probably need to purchase a copy of AS/NZS 4268 to find out if Australia and New Zealand accept this frequency. For all the rest of countries, I don't know how to find the information and look for your help. Frequency allocation tables seem not help too much. Your help is highly appreciated. Best regards, Grace Lin Sr. Compliance Engineer Crestron Electronics, Inc. New Jersey, USA 201-750-7004 ext. 11464 <http://www.crestron.com/> www.crestron.com - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
