I am trying to look at measuring connector/connector resistance through a lifetime of insertion/removal cycles – far more than what the connector specification addresses.
Anybody have a suggestion for the test gear. I would prefer to run it at signaling speed, but think I’m going to have to just look at the DC component. I’m thinking of a four wire resistance test non-in the nano ohm range. I’m also looking at doing some frequency stuff with a signal generator, a current shunt, and a matched impedance load but would prefer a “canned” solution for the test gear if anybody has it off the top of their head. – I wouldn’t speed anymore time than that. The whole thing is just a first order of approximation test. Once narrowed down, we”ll have to look at doing this properly. Gary ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________ - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
