Hi all, I have spindle speed control as a function of the S parameter working, just not the way I need it to work. If I have G-Code such as that listed at the bottom (3d_Chips with S substituted for Z). I get the spindle speed adjusting accordingly, except the motion stutters at each point, I presume waiting on the spindle. I am really using it to control a laser, so the spindle has no mass, and therefore can respond instantaneously. I do not see any parameters for spindle accel rate / time, etc. Is there a way to tell it to not wait, or set this accel to effectively infinite, and thus smoothly go through all of the points?
N110G1S27.372F225 N120Y-56.12S27.725 N130Y-56.105S27.894 N140Y-56.06S28.152 N150Y-56.051S28.184 N160Y-55.992S28.405 N170Y-55.902S28.651 N180Y-55.792S28.888 N190Y-55.661S29.115 N200Y-55.511S29.329 N210Y-55.343S29.53 N220Y-55.158S29.715 N230Y-54.957S29.883 N240Y-54.743S30.033 N250Y-54.516S30.164 N260Y-54.279S30.274 N270Y-54.033S30.364 N280Y-53.78S30.432 N290Y-53.522S30.477 N300Y-53.31S30.496 N310Y-53.262S30.5 Thanks, Eric ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys - and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
