Dino, The Omrons are similar (if not the same) as Yaskawas. I run the 5I20, 7I33 and 7I37s. Works good. Tuning is tricky as the drive/motor combo has a PID loop itself, and EMC adds and external position loop. Good luck.
Noel. Rogue Engineering Walnut Creek, CA -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dino Del Favero Sent: Tuesday, March 06, 2007 1:00 PM To: [email protected] Subject: [Emc-users] Connect Omron servos Hello list, I have to control a three axis milling machine using EMC2. The milling machine have three Omron Sigma II servo series http://www.omron-industrial.com/uk/home/products/motiondrives/ServoSystems/S ervoDrives/SigmaII/default.asp I am writing to ask it is better use the Montenc-Lite board or Mesa Electronics 5i20 + 7i33? Thanks Dino ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
