I had an interference problem that was corrected by putting a filter on the power input to the spindle VFD (HNC lathe). Only the spindle index was showing a problem. I am thinking that different systems have different thresholds of susceptibility. Maybe the source of your problem has a threshold characteristic.
I think you mentioned that your Z axis has always worked properly. Have you tried operating your X or Y from different points of the Z system? On Tue, 2007-12-11 at 21:39 +0000, Alan Condit wrote: > Chris Radek <[EMAIL PROTECTED]> writes: > > > > > On Tue, Dec 11, 2007 at 05:43:42PM +0000, Alan Condit wrote: > > > > > Can anyone see what is keeping the x axis from running??? > > > > Well what did you do that fixed Y? > > > Chris, > > I rebooted the machine. Honestly, one time when I would start it up Y would > work > and the next time it wouldn't. After changing the timing as Jeff suggested, it > worked sporadically, but now it seems to be working well (its spooky). > > Alan -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
