On Fri, 2007-12-14 at 14:46 -0600, Jon Elson wrote: > Kirk Wallace wrote: > > I need to use my mill manually while I am converting it to EMC. Because > > the spindle VFD is mounted at the back of the mill and I removed the > > DRO, I decided to just hook the linear encoders and the VFD to my Pico > > UPC and use EMC as a DRO and VFD controller. I figured, no big deal, put > > the hand-wheels back on, a little wiring, start EMC, unset E-stop, > > controller on, MDI, s1000 m3 and go. So far so good. The spindle is > > turning, I grab the X hand-wheel, give it a turn and ... the spindle > > stops and I get a following error. Dooh. > > > > I looked at my .hal files > It's not there, it is in the .ini file. Change FERROR and > MIN_FERROR to 100.0 and you shouldn't have the problem. > > Jon
Yea, thats what I meant, those configuration thingies. I put 100 in for FERROR and MIN_FERROR and it works fine. Kind of takes the wind out of my pvVCP sails. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
